Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 112)

Survey Pro Reference Manual
R-104
Post Process Settings
Job Settings Post Process or
Connect to Receiver Receiver Settings
The Post Process card is used to configure the settings for logging
post processing data, and the collecting and storing of post processing
points in Survey Pro.
Recording Interval : is where you set the period for
logging GPS raw data for post processing. Set it to Off to
disable post processing data collection in Survey Pro.
RTK Autonomous Points: is where you specify action to
take when accepting autonomous points during RTK
data collection. There are three options.
• Do not store: this option will prohibit acceptance
of autonomous points in RTK data collection
routines.
• Prompt for layer: this option will prompt the
user whenever an autonomous point is accepted.
The layer specified will be the default layer to
store autonomous points, but the user can over
ride at the prompt.
• Store on selected layer: this option will automatically store
autonomous points accepted during RTK data collection
routines on the specified layer.
Layer : displays the layer selected to store autonomous points.
Select Layer : opens up a layer prompt to allow you to select an
existing layer or create a new layer to store autonomous points.
Session Monitor
: is where you select to use the session monitoring
thresholds when collecting data with the Static / Rover Session
screen. To have Survey Pro display warnings during post processing
data collection, check Warn me if, and specify threshold values for the
number of SV, HDOP and memory.