Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 239)

Survey Menu – GPS Module
R-231
Adjust with Projection
Survey Adjust with Proj. .
The Adjust with Projection wizard is used in three different cases. It
is automatically opened to update job file points any time you change
the coordinate system site, such as solving a localization adjustment
or switching from grid to ground. It is automatically opened to
provide the option of updating job file points any time you change the
coordinate system definition, such as selecting a new mapping plane
zone or switching horizontal projection modes. Finally, it can be
opened by the user from the Survey menu to select and update points
with a projection adjustment.
The screens displayed will vary depending on the action that opened
the Adjust with Projection wizard. All of the screens are described
below.
Adjust with Projection – Select Points
The Adjust with Projection Select Points screen is used to select
points to be adjusted, and how to adjust them. This screen is only
shown when the wizard is opened from the menu.
To/From… : opens the Select Point(s) screen where you
can select points by specifying a point range.
Tap Points… : opens a map view where you can select
points by tapping them on the screen.
There are two adjustment modes:
Source to Destination Projection
: use this mode when
you want to adjust locations in one coordinate system
into locations in another coordinate system. You can
choose the source and destination coordinate systems
from the database. This mode has two options:
• Adjust all selected points: all eligible points will be
adjusted. Points with plane only locations will be
transformed into a temporary WGS84 geodetic
location using the source coordinate system, and
then into a new plane location using the destination coordinate