Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 280)

Survey Pro Reference Manual
R-272
Stake Points – Screen Three
Height of Rod: is the length of the rod.
Design Elev: displays the current design elevation,
which can be modified with the Change… button.
FORWARD / BACK: indicates if the rod must move
forward (toward the total station) or backward (away
from the total station).
Go RIGHT / Go LEFT: indicates if the rod must move to
the right or left from the total station’s point of view.
EDM: This button can be toggled to shoot in various
EDM modes. The options available depend on the total
station being used. Consult the total station’s
documentation for more information on the EDM modes
that it supports.
CUT / FILL: displays the required amount of cut or fill to
bring the stake point to the design point’s elevation.
Rod Elev: displays the elevation at the rod’s location computed from
the last shot.
Change… : is used to modify the current design elevation, which will
also modify the associated CUT/FILL value for the current station
being staked.
Shot : takes a shot to the prism and computes come/go, cut/fill
information.
Shot data: displays the measurements from the last shot.
Store… : stores the stake point.
Store/Tape… : accesses the Stake Out Point (Tape Offset) dialog box
(Page R-305), where the staked point can be stored that includes a
specified offset. The default value is the appropriate distance
correction to the design point.
Topo SS… : stores a side shot using the data from the last shot
taken. (This will not take a new shot.)