Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 47)

Job Menu
R-39
Defaults : will set the Serial Port, Baud Rate and Parity to their default
values based on the selected total station.
Instrument Settings… : accesses the settings that are specific for the
selected total station.
Send to Instrument : (applicable only to specific total stations) will
send the selected instrument settings to the total station. This is
particularly useful with robotic total stations after the total station
has been reset.
NOTICE:
The settings that are available after tapping the
Instrument Settings… button in non-leveling mode directly control
the settings that are built into the selected total station. Since total
station manufactures release new models every year, TDS cannot
maintain the necessary set up documentation for every existing
model and the models that are not yet available. The set up
procedure for your particular total station is better handled by the
total station manufacturer, or your instrument’s dealer.
If you have specific questions on the set up of your total station you
should refer to the documentation that was included with your total
station. The numbers listed below are provided for your convenience:
Trimble: 800-538-7800
Zeiss: 800-538-7800
Geodimeter: 800-538-7800
Leica: 800-327-4773
Nikon: 516-547-8500
Pentax: 800-729-1419
Topcon: 800-223-1130