Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 287)

Stakeout Menu
R-279
Cut / Fill: displays the required amount of cut or fill to bring the stake
point to the elevation of the reference line at the nearest
perpendicular.
Note: If staking beyond the end points of the reference line, or if the
reference line is defined by a 2D point, no vertical data is computed.
Meas : contains the information measured by the total station during
the previous shot.
Shot : takes a shot to the prism.
< Back : returns to Screen One.
Store : opens the Store Point dialog so you can store the last point
that was shot.
Remote Stake to Line
The content of the Stake to Line screen when running in remote mode
is nearly identical to running in non-remote mode, but the graphic
portion of the screen looks and behaves differently. The graphic is
more intuitive – simply point the data collector toward the total
station and the graphic tells you the orientation of the line and what
direction to travel to reach the line in the shortest distance. (See the
illustrations below.)
Graphic when prism is
greater than 10-feet
from the line. Graphic when prism is
between 1-foot and
10-feet from the line. Graphic when prism is
within 1-foot of the line Graphic when prism is
on the line or within the
Horizontal Distance
Tolerance specified in
the Stakeout Settings
screen (Page R-45).