Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 103)

Job Menu – GPS Module
R-95
Data Modem
: is where you select the type of modem. There will be
several options here, depending on your brand and model. If the
modem you are using is not in the list of known devices, you can
choose Generic Serial to set the communication parameters to work
with just about any external data modem.
Serial Port: displays the current settings for communication between
the receiver and the modem. This includes:
Baud Rate : displays the baud rate the receiver will use to
communicate with the modem.
Parity
: displays the parity the receiver will use to communicate with
the modem.
Serial Port : displays the serial port the receiver will use to
communicate with the modem.
Note: The following settings will vary depending on your choice of
modem. You may see one of the following:
Configure Serial / Configure…: opens the Modem Serial Comms.
screen (Page R-95), where you can change the settings for
communication between the receiver and the data modem.
Modem Settings: displays the settings last used by Survey Pro for
this modem type. This includes:
Channel : Displays the last radio channel when applicable.
Sensitivity : Displays the last radio sensitivity when applicable.
Mode : Displays the last radio base mode when applicable.
Configure Modem: Establishes communication with the radio
firmware and opens the Radio Settings screen (Page R-96), where you
can change the radio channel and sensitivity settings.
Select Modem : Allows you to select an existing data modem
configuration for your cell phone or IP modem. (IP modem is only
available when RTK Rover is selected for the receiver.)
Create : Opens the Cell Phone Settings or IP Modem Settings screen
(Page R-98 or R-99, respectively) depending on if Cell Phone or IP