Yokogawa PC-Based MX100 - Manual (Page 149)

7-9
SM MX100-01E
Procedures for Disassembly
1
2
3
4
5
6
7
Remove the Bezel
4. See section 7.2.1, “Disassembling the MX110-UNV-H04.”
Remove the Plate
5. See section 7.2.1, “Disassembling the MX110-UNV-H04.”
Remove the Module Case
6. See section 7.2.1, “Disassembling the MX110-UNV-H04.”
Remove the Module Back Plate
7. See section 7.2.1, “Disassembling the MX110-UNV-H04.”
Separate the MS Scanner Board and MS Input CTRL Board
8. Follow the procedure in section 7.2.1, “Disassembling the MX110-UNV-H04.”
Cautions during Reassembly
When reassembling the M10 Scanner Board and the M10 Input CTRL Board, make sure
to correctly position the connector pins when pushing in (if you push in the boards in the
wrong position, fire can result).
7.2 Disassembling the MX110 Analog Input Module