Yokogawa PC-Based MX100 - Manual (Page 148)

7-8
SM MX100-01E
7.2.2 Disassembling the MX110-UNV-M10
Opening the TR Cover
1. See section 7.2.1, “Disassembling the MX110-UNV-H04.”
Remove the Front TR Assembly (including the M10 Terminal Board. Only
applies if the /NC option is not installed).
2. Loosen the two screws indicated by the arrow in the figure below. The screws
cannot fall out, so loosen them completely.
3. Pull out the part indicated by the arrow in the figure below toward you as you look
at the figure, and remove the Front TR Assembly. Then remove the screw.
Screw
Front TR Assembly removed
7.2 Disassembling the MX110 Analog Input Module