Avaya P580 - Manual (Page 438)

Chapter 21
21-6 Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
set port auto-flush
Command Mode Global Configuration.
Description When auto-flush is enabled and the link to a port fails, all entries in the
address forwarding table that were learned for this port will be marked
invalid. The default value for auto-flush is disabled.
Syntax
Sample Output The following example enables auto-flush for port 2, on module 4.
(configure)# set port auto-flush 4/2 enable
Port auto-flush set successful: 4/2.
Systems P550R, P580, P880, and P882.
To Enable: set port auto-flush { | }
[...,{ | }] enable
To Disable: set port auto-flush { | }
[...,{ | }] disable
Table 21-4. Parameters, Keywords, Arguments
Name Definition
The module number on which you want to set auto-flush.
Auto-flush can be set at the module level or port level.
range> The port, or port range on which you want to enable auto-
flush.