Avaya P580 - Manual (Page 425)

Document No. 10-300090, Issue 1 20-11
Policy
ip access-list
Command Mode Global Configuration.
Description Creates a rule in an access control list (ACL). The rule that you set is
applied on all of the ports on the switch.
* Note: You must enable the ACL on which you want to set a rule. Only
one ACL can be enabled at a time.
The no command deletes an ACL rule or ACL.
Syntax
This command performs the same operation as the access-list command.
See that command for explanations of the keywords and variables and for
examples.
Systems P550R, P580, P880, and P882.
To Create a
Standard
ACL Rule: ip access-list
{permit [{use-priority | use-diffserv [mask] |
remark-diffserv [mask] | use-l2}] | deny | fwd1 |
fwd2 | fwd3 | fwd4 | fwd5 | fwd6 | fwd7 | fwd8}
{ | any | host
}
To Create an
Extended
ACL Rule: ip access-list
{permit [{use-priority | use-diffserv [mask] |
remark-diffserv [mask] | use-l2}] | deny | fwd1 |
fwd2 | fwd3 | fwd4 | fwd5 | fwd6 | fwd7 | fwd8}
{ |
any | host } [{lt | eq |
gt | range }] {
| any | host } [{lt
| eq | gt | range }]
[established]
To Remove an
ACL Rule or
ACL: no ip access-list [index>]