Avaya P580 - Manual (Page 47)

Document No. 10-300090, Issue 1 3-7
Appletalk
appletalk cable-range
Command Mode Interface Configuration.
Description Configure a cable range for an Appletalk Phase II for an interface. The no
form of this command disables Appletalk for this interface.
Syntax
Sample Output The following example configures a cable range of 222-224 for the
Appletalk interface on serial port 0.
(config-if:serial0)# appletalk cable-range 222.244
Systems P550R, P580, P880, and P882.
To Enable: appletalk cable-range []
To Disable: [no] appletalk cable-range
Table 3-5. Parameters, Keywords, Arguments
Name Definition
An optional parameter to indicate the range of the Appletalk
network values to be used on this interface. Specify start
and end values between 0 and 65279 and separate the values
with a hyphen.
The starting network number must be less than the ending
network number. When is omitted, the
interface tries to configure the Appletalk network and
obtains its configuration from another Appletalk router.
The Appletalk network address to assign to the interface.
When is omitted, the Appletalk address
defaults to 0.0.
• network - A 16-bit network number between 0 and
66279.
• node - An 8-bit node number between 0 and 254.