Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 76)

4-28
Model 3060E Model 3060E Model 3060E Model 3060E Model 3060E Chapter 4 Chapter 4 Chapter 4 Chapter 4 Chapter 4
Teledyne Electronic Technologies
Analytical Instruments
10. After pressing ACK , the screen indicates
that the system is calibrating and
displays the message:
PLEASE WAIT
...
• If you try to adjust the span level with
the signal output less than
1 /
3
of the span
set value , you will see the message
" CELL TOO WEAK " . If this occurs,
condition the sensor. Pressing ACK
returns you to the Analyze mode main
menu.
• The timer will start to count down.
11. After the calibration process is com-
pleted, the screen displays the present
oxygen content and the flow rate. Press
ACK to return to the Analyze mode.
12. If you press ACK , the system returns to
the Analyze mode, and the screen
displays the oxygen content of the
sample gas and all available menu
options.
VALVES: GAS SPAN
CALIBRATION IN PROGRESS
PLEASE WAIT . . .
1 2 3 4 5
VALVES: SHUTTING DOWN
1 2 3 4 5
TIME REMAINING 00 : 02 : 00
PLEASE WAIT . . .
YES NO ESC
VALVES: G AS SPAN
O XYG EN = 5.0 PPM O 2
PRESS ACK TO START THE
ANALYZE M O DE
--- PRESS ACK W HEN READY ---
1 2 3 4 5
ACK
VALVES: ANALYZE T=25C C=9:59
FLO W = 150.0 CC/M IN
AUTORANGE: 10 PPM
1 2 3 4 5
RANGE ALRM R
5.00
PPM 02
SETUP STDBY CAL
VALVES: G AS SPAN
% % % % % % % W ARNING % % % % % % %
CELL TO O W EAK
--- PRESS ACK W HEN READY ---
1 2 3 4 5
ACK