Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 39)

Teledyne Electronic Technologies
Analytical Instruments
3-13
Installation Installation Installation Installation Installation Ultra Ultra Ultra Ultra Ultra T T T T Trace Oxyg race Oxyg race Oxyg race Oxyg race Oxygen Anal en Anal en Anal en Anal en Analyz yz yz yz yzer er er er er
Figure 3-10. Installing the Calibrator.
NOTE: DO NOT wipe the wick with a tissue paper.
8. Place the calibrator electrode assembly back on the stainless steel
block.
9. Using the wrench (P/N W68) provided, secure the calibrator elec-
trode assembly on the stainless steel block by tightening the four
bolts and then tighten the bolts with the wrench (P/N W69) pro-
vided. See Figure 3-10.
10. Reconnect the current source connector to the calibrator.
PPB OXYGEN
POWER
ON
CONTRO L MODUL E
TELEDY NE ANALYTIC AL INSTR UMENTS
PPM OXY GEN
Calibrator
current source
connector
Figure 3-9. Soaking the Calibrator Wick with the Electrolyte.
PPB OXY GEN
POWER
ON
CO NTR O L MOD ULE
TELEDY NE ANALYT ICAL IN STRUM ENTS
PPM OXY GEN