Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 64)

4-16
Model 3060E Model 3060E Model 3060E Model 3060E Model 3060E Chapter 4 Chapter 4 Chapter 4 Chapter 4 Chapter 4
Teledyne Electronic Technologies
Analytical Instruments
Setup for Both Span Gas & Internal Calibrator (Full
Start)
15. After saying YES to the internal calibra-
tor, you are directed to fill the calibrator
with electrolyte. When done, press
ACK
to continue or ESC to return to the
previous screen.
16. After pressing ACK in step 15, the next
screen gives the option of connecting
the span gas tank. Press
YES to use span
gas in addition to the internal calibrator.
17. After pressing YES in step 16, the
system directs you to connect the span
gas tank to the appropriate inlet. When
done, press
ACK to continue.
18. The system directs you to connect the
sample gas tank to the appropriate inlet.
When done, press
ACK to continue.
19. The system directs you to check the
flow rate for 150 cc/min and to press
ACK when ready.
NOTE: Mass flow controller is preset to give 150 ± 3 sccm flow. However,
when a pneumatic valve does not open or the gas pressure drops to
a point where the mass flow controller is unable to deliver 150 sccm
flow, the analyzer will automatically shut down and display the
error message FLOW BELOW 20 SCCM. If this occurs, check the
sample/span gas and air pressure. Make sure that they are within
the recommended range.
VALVES: O FF
CAREFULLY FILL THE CALIBRATOR
W ITH A HALF CC OF CALIBRATIO N
ELECTRO LYTE
--- PRESS ACK W HEN READY ---
1 2 3 4 5
ESC ACK
VALVES: PURG E-FRO M -SPAN
FLO W = 49.5 CC/M IN LO W
1 2 3 4 5
CHECK THE FLO W RATE FO R
150 CC/M IN
--- PRESS ACK W HEN READY ---
ACK ESC
VALVES: O FF
CONNECT A SAM PLE GAS
TO THE SAM PLE PO RT
--- PRESS ACK W HEN READY ---
1 2 3 4 5
ACK ESC
VALVES: O FF
CONNECT THE SPAN GAS TANK
TO THE SPAN INLET
1 2 3 4 5
--- PRESS ACK W HEN READY ---
ACK ESC
VALVES: OFF
DO YOU WANT TO CONNECT THE
OPTIONAL SPAN GAS TANK
AT THIS TIME?
1 2 3 4 5
NO ESC YES