Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 59)

Teledyne Electronic Technologies
Analytical Instruments
4-11
Operations Operations Operations Operations Operations Ultra Ultra Ultra Ultra Ultra T T T T Trace Oxyg race Oxyg race Oxyg race Oxyg race Oxygen Anal en Anal en Anal en Anal en Analyz yz yz yz yzer er er er er
6. Press ACK so that the next power-up
will result in a cold start.
7. When you press ACK the first system
menu will appear.
To
COLD START , turn the power OFF,
then ON after 10 seconds.
8. The first screen on power-up should
indicate a COLD START and the current
software revision (this may be different
from what appears in picture on the
left).
Full Start Mode
1. Switch power to ON. The first screen
displays the name of the company,
instrument model number, and software
version. You are then asked to set the
time/date. Use the
UP and DOWN keys
to scroll, SELEC to enter the desired
value, and ACCPT when done.
You may accept the default time and
date values if you do not plan on per-
forming scheduled zero and span
operations at this time. You may set
time/date any time by pressing
SETUP
from Analyzer mode.
VALVES: O FF
% % % % % % W ARNING: % % % % % %
PRESS ACK TO PRESET SYSTEM TO
FACTO RY SETTING S. NEXT PO W ER
O N W ILL RESULT IN A CO LD START.
1 2 3 4 5
ACK ESC
VALVES: OFF
WARNING: IF THIS IS THE FIRST
SETUP THE FULL STARTUP
IS REQUIRED.
1 2 3 4 5
FULL QUICK
VALVES: O FF
SET TIM E/DATE
1-01-93 12 : 03 AM
1 2 3 4 5
SELEC UP DOW N ACCPT