Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 68)

4-20
Model 3060E Model 3060E Model 3060E Model 3060E Model 3060E Chapter 4 Chapter 4 Chapter 4 Chapter 4 Chapter 4
Teledyne Electronic Technologies
Analytical Instruments
31. The Ultra Trace sensor is reconnected.
After the sensor connects, the system
automatically returns you to the Ana-
lyze mode main menu.
• From the Analyze mode you can
calibrate, set up the alarms, modem,
etc., set the range, or go to stand-by.
Quick Start Mode
1. Turn the power switch ON . The first
screen displays the name of the com-
pany, instrument model numbers and
software version. You are asked to wait
for start-up initialization.
2. After a few minutes, the screen displays
the options FULL or QUICK START
mode. Press QUICK for QUICK START .
3. After pressing QUICK the screen directs
you to select the background gas using
the knob on the front panel. Press
ACCPT after selection. Press ESC to
return to the previous screen.
4. After you press ACCPT to select a
background gas, the screen directs you
to connect the sample gas to the sample
port. Press
ACK or ESC to continue.
VALVES: ANALYZE T=25C
FLO W = 150.0 CC/M IN
AUTORANGE: 10 PPM
1 2 3 4 5
RANGE ALRM R
5.00
PPM 02
SETUP STDBY CAL
VALVES: ANALYZE
CONNECTING SENSOR
PLEASE WAIT . . .
1 2 3 4 5
VALVES: OFF
1 2 3 4 5
WARNING: IF THIS IS THE FIRST
SETUP THE FULL STARTUP
IS REQUIRED
FULL QUICK
VALVES: OFF
1 2 3 4 5
CONNECT A SAMPLE GAS
TO THE SAMPLE PORT
. . . PRESS ACK WHEN READY . . .
ACK ESC