Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 28)

3-2
Model 3060E Model 3060E Model 3060E Model 3060E Model 3060E Chapter 3 Chapter 3 Chapter 3 Chapter 3 Chapter 3
Teledyne Electronic Technologies
Analytical Instruments
2. Standard accessory kit for the 3060E (P/N A59582):
Qty P/N Description
12 G284 Gaskets, VCR-type
6 G352 Weld glands, male, VCR-type
6 N284 Nuts, female
1 W66 Wrench, open end, ¼ " - 5 /
16
"
1 S915 Screwdriver, #0 Phillips drive
1 S916 Screwdriver, slotted drive
1 S914 Socket, 7 /
16
" for ¼ " drive
1 R1549 Rachet, quick release, ¼ " drive
1 W68 Allen wrench, with handle, 7 /
64
"
1 W69 Allen wrench, long arm, 7 /
64
"
1 A51934 KOH electrolyte
1 A64239 Calibration electrolyte
1 B51752 Syringe 50 cc (Assembled)
1 A51886 Syringe 2 cc (Assembled)
1 T1052 Fritted glass tube
1 Safety glasses
1 pr. Gloves, rubber
1 MP-A56133 Procedure for Preparation of Electrolyte
3. Instruction Manual
4. Quick Reference: Start Up
Cautions and Warnings
1. Always use extreme care when handling the electrolyte bottles.
Electrolyte can cause skin irritation. If the electrolyte comes into
contact with skin, immediately wash the affected area with cold
water.
CAUTION: The sensor electrolyte is caustic. Protective equipment
including, but not limited to, gloves and safety glasses should
be worn while handling electrolyte. See the Material Safety
Data Sheets for potential hazards and corrective action in
case of accident.
2. Use the correct syringe for each type of electrolyte. The 50 cc
syringe is used with the sensor electrolyte. The 2 cc syringe is used
with the calibrator electrolyte.
3. Before adding electrolyte to the sensor, examine the electrical
connections on the sensor body to make sure that they are firmly
secured to the proper terminals.