Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 60)

4-12
Model 3060E Model 3060E Model 3060E Model 3060E Model 3060E Chapter 4 Chapter 4 Chapter 4 Chapter 4 Chapter 4
Teledyne Electronic Technologies
Analytical Instruments
2. After a few minutes, the screen displays
the options
FULL
or
QUICK
start mode.
Press
FULL
to select
FULL START
.
NOTE: Holding down the orange key while pressing QUICK will allow you
to choose a cold start for the next restart.
3. The screen instructs you to fill the
Ultra Trace sensor with electro-
lyte. Press
ACK
to continue or
ESC
to return to the previous screen.
This ensures that the sensor has
electrolyte.
4. The next screen directs you to
select the background gas. After
selecting the gas, press
ACK to
continue. Press
ESC
to return to
the previous screen.
5. The system asks if you will use
the internal calibrator.
• To use the internal calibrator
only, press
YES and continue
on to step 6.
• To set up for calibrations
using a span gas only, press
NO
and go to step 11.
• To use both a span gas and the
internal calibrator, press
YES
and go to step 15.
VALVES: O FF
W ARNING: IF THIS IS THE FIRST
SETUP THE FULL STARTUP
IS REQ UIRED.
1 2 3 4 5
FULL Q UICK
VALVES: OFF
CAREFULLY FILL THE SENSOR
W ITH ELECTROLYTE SO THAT THE
LEVEL IS BETW EEN FILL M ARKS
--- PRESS ACK W HEN READY ---
ESC ACK
1 2 3 4 5
VALVES: OFF
SELECT THE BACKGROUND GAS
USING THE KNOB ON THE STATUS PANEL
ESC ACK
1 2 3 4 5
VALVES: O FF
DO YO U W ANT TO USE THE
INTERNAL CALIBRATOR?
ESC NO
1 2 3 4 5
YES