Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 47)

Teledyne Electronic Technologies
Analytical Instruments
3-21
Installation Installation Installation Installation Installation Ultra Ultra Ultra Ultra Ultra T T T T Trace Oxyg race Oxyg race Oxyg race Oxyg race Oxygen Anal en Anal en Anal en Anal en Analyz yz yz yz yzer er er er er
7. Water Reservoir and Reservoir Drain
The water reservoir supplies water for automatic replenishment of
water to the Ultra Trace sensor. Before transporting the analyzer, all
water must be drained by opening the reservoir drain.
8. Calibrator Bypass
This outlet is used when purging the Faradaic calibrator, such as
after replacing the electrolyte. It prevents a spike from appearing in
analyzer output due to contamination with air.
Figure 3-15. Gas Line/Rear Panel Connections
SAMPLE
BYPASS
OUT
CALIBRATOR
BYPASS
OUT
WATER
RESERVOIR
RESERVOIR
DRAIN
SPARGER
VENT
SPAN GAS
IN
AIR
IN
SAMPLE IN
SAMPLE/SPAN
VENT
AC POWER IN
5 ALARM CIRCUIT
CONNECTIONS
RS232 SERIAL
PORT (9 PIN D-SUB)
(MALE)
COOLING
FAN
4 SIGNAL CONNECTIONS
(2) 0-1VDC & (2) 4-20MADC
INCLUDING RANGE IDENTIFYING OUTPUT
PARALLEL (PRINTER)
PORT (25 PIN D-SUB)
(FEMALE)