Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 4)

Teledyne Electronic Technologies
Analytical Instruments
Model 3060E Ultra Trace Sensor
iv
Faradaic Calibrator ............................................................................................. 3-9
Adding Electrolyte to the Calibrator ............................................................ 3-10
Adding Water to the Reservoir ..................................................................... 3-14
Level Detector and Solenoid Switch ............................................................ 3-15
Electrical Installation ........................................................................................... 3-16
Electrical Connections .................................................................................. 3-16
Voltage Selection and Fuse Changing .......................................................... 3-17
Gas Line Connections .......................................................................................... 3-19
Installation Checklist ........................................................................................... 3-22
4 Operations
Overview ............................................................................................................. 4-1
Front Panel Controls and Indicators .................................................................... 4-2
Sample System Status Panel ........................................................................ 4-2
LED Display ................................................................................................ 4-3
Computer Control Module ........................................................................... 4-3
Sensor Compartment Temperature Controller ............................................. 4-6
Ultra Trace Sensor Electrolyte Temperature ................................................ 4-6
Rear Panel Connections ....................................................................................... 4-6
Operating the Analyzer ........................................................................................ 4-7
Start-up Checklist ........................................................................................ 4-7
Modes of Operation ...................................................................................... 4-8
Cold Start 4-8
Warm Start .......................................................................................... 4-9
Full Start Versus Quick Start .............................................................. 4-9
Forcing a COLD START by turning Power OFF/ON ....................... 4-9
Forcing a Cold Start Without First Shutting Down ............................. 4-10
Full Start Mode ............................................................................................ 4-11
Full Start Options ......................................................................................... 4-13
Setup for Internal Calibrator Use (Full Start) ...................................... 4-13
Setup for Span Gas Use (Full Start) .................................................... 4-15
Setup for Both Span Gas & Internal Calibrator (Full Start) ................ 4-16
Quick Start Mode ......................................................................................... 4-20
Analyze Mode .............................................................................................. 4-23
Conditioning the Ultra Trace Sensor .................................................... 4-23
Span Calibration Using an External Span Gas ............................................ 4-25
Span Calibration Using the Internal Calibrator ................................... 4-29