Printronix PrintNet Enterprise - Manual (Page 67)

Defining Printer Properties
67
Download Mode: Identifies how PNE downloads files and configurations to
the printer. Access Method is the only option available.
Printer Timeout on Firmware Download: Specifies the number of minutes
the printer waits for data while downloading a file from the host computer. If a
stall lasts for more than the specified time, the printer times out and the
download terminates. If you have a slow connection between PNE and the
printer, you may need to define a longer Download Timeout period.
The Download Timeout range is between 1 and 60 minutes. The default is
2 minutes.
Firmware Download Initial Delay (Sec): Specifies the number of seconds
PNE waits before sending files to the printer. If the printer is not ready within
the specified time, the download will terminate, and the Status and Error Log
will report Connection Refused.
If you receive this error message, increase the initial delay time. The default is
60 (seconds).
Network Sub-Tab
Figure 51. Printer Properties: Connections – Network Sub-Tab
Enter the printer’s IP Address and Port Number. (Click Default to reset the
Port Number to 3001.) The Time Out option sets the amount of time, in
seconds, PNE waits for a response from the printer after sending a command.
If there is no response in the specified amount of time, an error message
appears in the Status and Error Log pane. If you have a slow connection
between PNE and the printer, you may need to define a longer Time Out
period. Define the Time Out between 5 and 300 seconds (the default is 15
seconds).