Printronix PrintNet Enterprise - Manual (Page 171)

Pattern Character Tab
171
Character: Selects the character that identifies the pattern character. The
available values range from 0x20 to 0xFF. The values 0x00 to 0x1F are
reserved. The values are listed with their hex value and printable character. If
you select a character already defined in the drop-down list, the properties for
the character will display in the Note and Range fields. You can change the
data and click
Update to update the definition in the Pattern Character List.
Note: A short note, description, or name of the pattern character. This will
appear in pop-up menus where you insert and use pattern characters.
Range: The range of values datastream adapter checks against.
NOTE: A continuous interval is separated by two dots, e.g., a..z .
Enter hex values with the prefix 0x . To define a continues hex interval, enter
0xNN..0xNN (where NN is a value ranging from 00 to FF).
You can define multiple intervals per pattern character by separating the
intervals with a
, (comma) or a space character.
NOTE: To include an interval separator, enter them either as hex, e.g., 0x20
and 0x2C , or make it part of a continues interval, e.g., 0x10..0x30 .
Default Pattern Characters
You can select a set of default pattern characters by using the Range drop-
down list. The Character and Note fields of the default pattern characters are
set to the values listed in Table 8. If you choose a default pattern and the
identifier (character) is already in use, the first unused identifier from the
Character drop-down list is used.
Table 8. Default Pattern Characters
Range
Identifier
(Character)
Note
0..9 # Numerals
A..Z U Uppercase
a..z L Lowercase
A..Z, a..z A Alpha
0..9, A..Z, a..z @ Alpha Numeric
0..9, A..F, a..f H Hex Values
0x00..0x1F C Ctrl-Codes
0x20..0x7F P Printables
0x80..0xFF S Upper Set