Printronix PrintNet Enterprise - Manual (Page 253)

Using Reports
253
Using Reports
To make sure the correct report is transmitted to the operator panel LCD, add
the following entry to the mapping table.
Figure 221. Defining Entries in the GPIO Manager
Once the report has been defined and the Send Report action has been
selected, the parameter block allows you to specify what is to be done with
this report.
The Source drop down menu allows you to select a report previously created.
The Destination options tell the system where to transmit the report. The
Seconds field sets the time the report will be visible (applicable only to the
operator panel LCD). See Figure 221.