Printronix PrintNet Enterprise - Manual (Page 226)

226
Chapter 6 Event To Action Mapping
• Label Printed
This event occurs when a number of labels stored in the printer have
finished printing. If the labels print as a single job without any wait time,
the event will be a short pulse. If the printer is placed in local mode and
the labels are printed using the
print next label action, the event will
happen once for each label.
• Overstrike Pending
The printer generates this event when a label overstrike is pending.
• Label Completed
The printer generates this event when a label is completed.
• Label Rejected
The printer generates this event when a label is rejected.
• Label Canceled
The printer generates this event when a label is canceled.
• Label Failed
The printer generates this event when a label fails to print.
• Label Present
In label peel off applications, this event happens when the label present
sensor detects a label in position (ready for application). It may be used to
signal the availability of a label to an applicator system.
• Label Taken
This event generates when the label is taken from its ready to apply
position. It can be used to tell the host that a new label can be printed.
• Labels Pending, None
The printer generates this event when it has no more pending labels to
print.
• End Paper Move
This event indicates the end of paper motion.
• Cutter Cycled
The printer generates this event when the cutter cycle is completed.
• Sensor Event
This event generates when the action to set the sensor to ignored on or
off, either is executed or failed.
• Printer Error/Printer Warning
The printer generates this event when errors or warnings occur or are
cleared. You can select the actual error or warning as the event.