Printronix PrintNet Enterprise User Manual

Page 138

138

Chapter

Set Wireless Properties

LEAP is to enable LEAP operation.

Kerberos is to enable Kerberos operation.

Sub-Channel:

Determines the channel for the radio frequency card:

1 through 15 and Default.

Transmit Power:

Determines the wattage of the transmission power: Max

(100 mW - Default), 50% (30 mW), 25% (15 mW), 10% (5 mW), and

1% (1 mW).

Transmission Rate:

Currently unavailable. Determines the rate of data

transmission from the radio frequency card to the access point: 1 MHz, 2MHz,
5 MHz, 11 MHz, and Automatic.

Preamble Length:

Determines the size of the packet header generated by

the access point: Long, Short, or Default (set by the access point).

Profile:

Determines the 802.11g Wireless (Wi-Fi) mode in which to operate.

International Roaming:

Check this check box to enable roaming outside the

home country.

When you are finished, click

Send

to transmit the values to the printer.

NOTE:

If the NIC has a password assigned to the user

root

, then a Telnet

root password is required. See “Security Tab” on page 63.

If you are not going to modify settings on any other tabs, you must update the
printer for the settings to take effect. Click

Update

to update the printer.

IMPORTANT

Make sure the settings match those configured in the Access Point.