ZyXEL Communications Version 1.03 - Manual (Page 208)

Chapter 19 IP Configuration
NetAtlas Workgroup User’s Guide
208
The following table describes the related labels in this screen.
19.6 DVMRP
DVMRP (Distance Vector Multicast Routing Protocol) is a protocol used for routing multicast
data within an autonomous system (AS). This DVMRP implementation is based on draft-ietf-
idmr-dvmrp-v3-10. DVMRP provides multicast forwarding capability to a layer 3 switch that
runs both the IPv4 protocol (with IP Multicast support) and the IGMP protocol. The DVMRP
metric is a hop count of 32.
IGMP is a protocol used for joining or leaving a multicast group. You must have IGMP
enabled when you enable DVMRP.
To open the DVMRP screen, right-click on a switch in the Device Panel list and click
Configuration > IP Configuration > DVMRP.
Table 114 IP Configuration: DHCP: Relay
LABEL DESCRIPTION
Relay
Active Select this check box to enable DHCP relay.
Remote
DHCP Server
1 .. 3
Enter the IP address of a DHCP server in dotted decimal notation.
Relay Agent
Information
Select the Option 82 check box to have the switch add information (slot number, port
number and VLAN ID) to client DHCP requests that it relays to a DHCP server.
Information This read-only field displays the system name you configure in the System
Information screen (refer to Section 14.1 on page 143 ).
Select the check box for the switch to add the system name to the client DHCP
requests that it relays to a DHCP server.
Apply Click Apply to save the changes.