ZyXEL Communications Version 1.03 - Manual (Page 180)

Chapter 17 Multicast Configuration
NetAtlas Workgroup User’s Guide
180
17.2 Multicast Settings
To configure multicast settings, click Configuration > Multicast Configuration to display
the configuration screen.
"
For devices that do not support the multicast feature, this screen only allows
you to configure the IGMP Snooping option.
Figure 128 Multicast Configuration: Multicast Settings
The following table describes the labels in this screen.
Table 93 Multicast Configuration: Multicast Settings
LABEL DESCRIPTION
IGMP Snooping Select Active to enable IGMP snooping to forward group multicast traffic only to
ports that are members of that group.
Host Timeout Specify the time (from 1 to 16,711,450) in seconds that elapses before the switch
removes an IGMP group membership entry if it does not receive report messages
from the port.
Leave Timeout Enter an IGMP leave timeout value (from 1 to 16,711,450) in seconds. This
defines how many seconds the switch waits for an IGMP report before removing
an IGMP snooping membership entry when an IGMP leave message is received
from a host.
802.1p Priority Select a priority level (0-7) to which the switch changes the priority in outgoing
IGMP control packets. Otherwise, select No-Change to not replace the priority.
IGMP Filtering Select Active to enable IGMP filtering to control which IGMP groups a subscriber
on a port can join.