beautypg.com

4 port link aggregation, Table 81 ethernet port configuration: port vlan – ZyXEL Communications Version 1.03 User Manual

Page 166

background image

Chapter 16 Ethernet Port Configuration

NetAtlas Workgroup User’s Guide

166

The following table describes the labels in this screen.

16.4 Port Link Aggregation

Use the Port Link Aggregation screen to configure a port trunk group and set LACP timeout.
To open the configuration screen, right-click on the switch in the Device List Panel, and click
Configuration > Ethernet Port > Port Link Aggregation. Then select a device and the
port(s) to which you want to apply this configuration.

Figure 116 Ethernet Port Configuration: Port Link Aggregation

Table 81 Ethernet Port Configuration: Port VLAN

LABEL

DESCRIPTION

Ingress

This feature is not supported on all models.
If this check box is selected for a port, the device discards incoming frames for VLANs

that do not include this port in its member set.

PVID

Each port on the switch is capable of passing tagged or untagged frames. To forward a

frame from an IEEE 802.1Q VLAN-unaware switch to an IEEE 802.1Q VLAN-aware

switch, the switch first decides where to forward the frame, and then inserts a VLAN tag

reflecting the default ingress port's VLAN ID, the PVID. The default PVID is VLAN 1 for

all ports, but this can be changed to any number between 1 and 4094.

GVRP

Select the check box to permit VLAN groups beyond the local switch on this port. GVRP

(GARP VLAN Registration Protocol) is a registration protocol that defines a way for

switches to register necessary VLAN members on ports across the network.

Acceptable

Frame Type

Specify the type of frames allowed on a port. Choices are All and Tag Only. Select All

to accept all frames with untagged or tagged frames on this port. This is the default

setting. Select Tag Only to accept only tagged frames on this port. All untagged frames

are dropped.

VLAN

Trunking

Enable VLAN trunking on ports connected to other switches or routers (but not ports

directly connected to end users) to allow frames belonging to unknown VLAN groups to

pass through the switch.

Apply

Click Apply to save the changes.