beautypg.com

3 remote management, Figure 90 system configuration: snmp conf, Table 56 system configuration: snmp conf – ZyXEL Communications Version 1.03 User Manual

Page 133

background image

Chapter 13 System Configuration

NetAtlas Workgroup User’s Guide

133

Figure 90 System Configuration: SNMP Conf.

The following table describes the labels in this screen.

13.3 Remote Management

Remote management allows you to determine which services/protocols can access which
device interface (if any) from which computers. You can customize the service port and the
secured client IP address to enhance security and flexibility.
To open this screen, right-click on the switch in the Device List Panel, and click
Configuration > System Configuration > Remote Mgmt..

Table 56 System Configuration: SNMP Conf.

LABEL

DESCRIPTION

Read Community

Enter the get community, which is the password for the incoming Get- and

GetNext- requests from the management station.

Read/Write Community Enter the set community, which is the password for incoming Set- requests

from the management station.

Trap Community

Enter the trap community, which is the password sent with each trap to the

SNMP manager.

Apply

Click Apply to save your changes back to the switch.

Trap Destination

Enter the IP addresses of up to four stations to send your SNMP traps to.

Apply

Click Apply to save the trap destination changes back to the switch.