4 vpn wizard network setting, Figure 26 vpn wizard: gateway setting, Table 15 vpn wizard: gateway setting – ZyXEL Communications ZyWALL 2 Plus User Manual
Page 80

Chapter 3 Wizard Setup
ZyWALL 2 Plus User’s Guide
80
Figure 26 VPN Wizard: Gateway Setting
The following table describes the labels in this screen.
3.4 VPN Wizard Network Setting
Use this screen to name the VPN network policy (IPSec SA) and identify the devices behind
the IPSec routers at either end of a VPN tunnel.
Table 15 VPN Wizard: Gateway Setting
LABEL
DESCRIPTION
Gateway Policy
Property
Name
Type up to 32 characters to identify this VPN gateway policy. You may use any
character, including spaces, but the ZyWALL drops trailing spaces.
Gateway Policy
Setting
My ZyWALL
When the ZyWALL is in router mode, enter the WAN IP address or the domain name
of your ZyWALL or leave the field set to 0.0.0.0.
The ZyWALL
uses its current WAN IP address (static or dynamic) in setting up the
VPN tunnel if you leave this field as 0.0.0.0. If the WAN connection goes down, the
ZyWALL uses the dial backup IP address for the VPN tunnel when using dial backup
or the LAN IP address when using traffic redirect.
The VPN tunnel has to be rebuilt if this IP address changes.
When the ZyWALL is in bridge mode, this field is read-only and displays the
ZyWALL’s IP address.
Remote
Gateway
Address
Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) in the field below to identify the remote IPSec router by its IP address or a
domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN
IP address.
Back
Click Back to return to the previous screen.
Next
Click Next to continue.