ZyXEL Communications ZyWALL 2 Plus - Manual (Page 579)

Chapter 41 Firmware and Configuration File Maintenance
ZyWALL 2 Plus User’s Guide
579
41.4.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure shown next.
Procedures using other serial communications programs should be similar.
1 Display menu 24.6 and enter “y” at the following screen.
Figure 402 System Maintenance: Restore Configuration
2 The following screen indicates that the Xmodem download has started.
Figure 403 System Maintenance: Starting Xmodem Download Screen
3 Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
Figure 404 Restore Configuration Example
4 After a successful restoration you will see the following screen. Press any key to restart
the ZyWALL and return to the SMT menu.
Figure 405 Successful Restoration Confirmation Screen
41.5 Uploading Firmware and Configuration Files
This section shows you how to upload firmware and configuration files. You can upload
configuration files by following the procedure in
Section 41.4 on page 577 or by following the
instructions in Menu 24.7.2 - System Maintenance - Upload System Configuration File
(for console port).
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...CCCCCCCCC
Save to ROM
Hit any key to start system reboot.
Type the configuration file’s location,
or click Browse to search for it.
Choose the Xmodem protocol.
Then click Send.