ZyXEL Communications ZyWALL 2 Plus - Manual (Page 391)

Chapter 21 Remote Management
ZyWALL 2 Plus User’s Guide
391
21.13 FTP
You can use FTP (File Transfer Protocol) to upload and download the ZyWALL’s firmware
and configuration files, please see the User’s Guide chapter on firmware and configuration file
maintenance for details. To use this feature, your computer must have an FTP client.
To change your ZyWALL’s FTP settings, click ADVANCED > REMOTE MGMT > FTP.
The screen appears as shown. Use this screen to specify which interfaces allow FTP access
and from which IP address the access can come.
"
It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 260 ADVANCED > REMOTE MGMT > FTP
The following table describes the labels in this screen.
Table 123 ADVANCED > REMOTE MGMT > FTP
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the ZyWALL using
this service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Apply Click Apply to save your customized settings.
Reset Click Reset to begin configuring this screen afresh.