ZyXEL Communications ZyWALL 2 Plus - Manual (Page 470)

Chapter 27 Introducing the SMT
ZyWALL 2 Plus User’s Guide
470
Figure 301 Main Menu (Bridge Mode)
The following table describes the fields in this menu.
Copyright (c) 1994 - 2007 ZyXEL Communications Corp.
ZyWALL 2 Plus Main Menu
Getting Started Advanced Management
1. General Setup 21. Filter and Firewall Setup
22. SNMP Configuration
23. System Password
24. System Maintenance
7. Wireless Setup
99. Exit
Enter Menu Selection Number:
Table 170 Main Menu Summary
NO
.
MENU TITLE FUNCTION
1 General Setup Use this menu to set up device mode, dynamic DNS and
administrative information.
2 WAN Setup Use this menu to clone a MAC address from a computer on your LAN
and configure the backup WAN dial-up connection.
3 LAN Setup Use this menu to apply LAN filters, configure LAN DHCP and TCP/IP
settings.
4 Internet Access Setup Configure your Internet access setup (Internet address, gateway, login,
etc.) with this menu.
5 DMZ Setup Use this menu to apply DMZ filters, and configure DHCP and TCP/IP
settings for the DMZ port.
7 Wireless Setup Use this menu to configure WLAN DHCP and TCP/IP settings for the
wireless LAN interface.
11 Remote Node Setup Use this menu to configure detailed remote node settings (your ISP is
also a remote node) as well as apply WAN filters.
12 Static Routing Setup Configure IP static routes in this menu.
15 NAT Setup Use this menu to configure Network Address Translation.
21 Filter and Firewall
Setup
Configure filters and activate/deactivate the firewall.
22 SNMP Configuration Use this menu to configure SNMP-related parameters.
23 System Password Change your password in this menu (recommended).
24 System Maintenance From displaying system status to uploading firmware, this menu
provides comprehensive system maintenance.
26 Schedule Setup Use this menu to schedule outgoing calls.
99 Exit Use this menu to exit (necessary for remote configuration).