ZyXEL Communications ZyWALL 2 Plus - Manual (Page 64)

Chapter 2 Introducing the Web Configurator
ZyWALL 2 Plus User’s Guide
64
2.4.6 Port Statistics
Click Port Statistics in the HOME screen. Read-only information here includes port status
and packet specific statistics. The Poll Interval(s) field is configurable.
Figure 10 HOME > Show Statistics
The following table describes the labels in this screen.
LOGS View Log Use this screen to view the logs for the categories that you
selected.
Log Settings Use this screen to change your ZyWALL’s log settings.
Reports Use this screen to have the ZyWALL record and display network
usage reports.
MAINTENANCE General This screen contains administrative.
Password Use this screen to change your password.
Time and Date Use this screen to change your ZyWALL’s time and date.
Device Mode Use this screen to configure and have your ZyWALL work as a
router or a bridge.
F/W Upload Use this screen to upload firmware to your ZyWALL
Backup &
Restore
Use this screen to backup and restore the configuration or reset
the factory defaults to your ZyWALL.
Restart This screen allows you to reboot the ZyWALL without turning the
power off.
Diagnosis Use this screen to have the ZyWALL generate and send
diagnostic files by e-mail and/or the console port.
LOGOUT Click this label to exit the web configurator.
Table 6 Screens Summary (continued)
LINK TAB FUNCTION
Table 7 HOME > Show Statistics
LABEL DESCRIPTION
Port These are the ZyWALL’s interfaces.
Status For the WAN and dial backup ports, this displays the port speed and duplex setting
if you’re using Ethernet encapsulation and Down (line is down), Idle (line (ppp)
idle), Dial (starting to trigger a call) or Drop (dropping a call) if you’re using PPPoE
encapsulation. Dial backup is not available in bridge mode.
For the LAN, DMZ and WLAN ports, this displays the port speed and duplex setting.