ZyXEL Communications ZyWALL 2 Plus - Manual (Page 396)

Chapter 21 Remote Management
ZyWALL 2 Plus User’s Guide
396
21.17 Configuring CNM
Vantage CNM is disabled on the device by default. Click ADVANCED > REMOTE MGMT
> CNM to configure your device’s Vantage CNM settings.
Figure 264 ADVANCED > REMOTE MGMT > CNM
The following table describes the labels in this screen.
Table 127 ADVANCED > REMOTE MGMT > CNM
LABEL DESCRIPTION
Registration
Information
Registration Status This read only field displays Not Registered when Enable is not selected.
It displays Registering when the ZyWALL first connects with the Vantage
CNM server and then Registered after it has been successfully registered
with the Vantage CNM server. It will continue to display Registering until it
successfully registers with the Vantage CNM server. It will not be able to
register with the Vantage CNM server if:
The Vantage CNM server is down.
The Vantage CNM server IP address is incorrect.
The Vantage CNM server is behind a NAT router or firewall that does not
forward packets through to the Vantage CNM server.
The encryption algorithms and/or encryption keys do not match between the
ZyWALL and the Vantage CNM server.
Last Registration Time This field displays the last date (year-month-date) and time (hours-minutes-
seconds) that the ZyWALL registered with the Vantage CNM server. It
displays all zeroes if it has not yet registered with the Vantage CNM server.
Refresh Click Refresh to update the registration status and last registration time.
Vantage CNM Setup
Enable Select this check box to allow Vantage CNM to manage your ZyWALL.
Vantage CNM Server
Address
If the Vantage server is on the same subnet as the ZyWALL, enter the private
or public IP address of the Vantage server.
If the Vantage CNM server is on a different subnet to the ZyWALL, enter the
public IP address of the Vantage server.
If the Vantage CNM server is on a different subnet to the ZyWALL and is
behind a NAT router, enter the WAN IP address of the NAT router here.