ZyXEL Communications ZyWALL 2 Plus - Manual (Page 547)

Chapter 38 Filter Configuration
ZyWALL 2 Plus User’s Guide
547
The following table describes how to configure your TCP/IP filter rule.
Table 204 Menu 21.1.1.1: TCP/IP Filter Rule
FIELD DESCRIPTION
Active Press [SPACE BAR] and then [ENTER] to select Yes to activate the filter rule or No
to deactivate it.
IP Protocol Protocol refers to the upper layer protocol, e.g., TCP is 6, UDP is 17 and ICMP is 1.
Type a value between 0 and 255. A value of 0 matches ANY protocol.
IP Source Route Press [SPACE BAR] and then [ENTER] to select Yes to apply the rule to packets
with an IP source route option. Otherwise the packets must not have a source route
option. The majority of IP packets do not have source route.
Destination
IP Addr Enter the destination IP Address of the packet you wish to filter. This field is ignored
if it is 0.0.0.0.
IP Mask Enter the IP mask to apply to the Destination: IP Addr.
Port # Enter the destination port of the packets that you wish to filter. The range of this field
is 0 to 65535. This field is ignored if it is 0.
Port # Comp Press [SPACE BAR] and then [ENTER] to select the comparison to apply to the
destination port in the packet against the value given in Destination: Port #.
Options are None, Equal, Not Equal, Less and Greater.
Source
IP Addr Enter the source IP Address of the packet you wish to filter. This field is ignored if it
is 0.0.0.0.
IP Mask Enter the IP mask to apply to the Source: IP Addr.
Port # Enter the source port of the packets that you wish to filter. The range of this field is 0
to 65535. This field is ignored if it is 0.
Port # Comp Press [SPACE BAR] and then [ENTER] to select the comparison to apply to the
source port in the packet against the value given in Source: Port #.
Options are None, Equal, Not Equal, Less and Greater.
TCP Estab This field is applicable only when the IP Protocol field is 6, TCP. Press [SPACE
BAR] and then [ENTER] to select Yes, to have the rule match packets that want to
establish a TCP connection (SYN=1 and ACK=0); if No, it is ignored.
More Press [SPACE BAR] and then [ENTER] to select Yes or No. If Yes, a matching
packet is passed to the next filter rule before an action is taken; if No, the packet is
disposed of according to the action fields.
If More is Yes, then Action Matched and Action Not Matched will be N/A.
Log Press [SPACE BAR] and then [ENTER] to select a logging option from the following:
None – No packets will be logged.
Action Matched - Only packets that match the rule parameters will be logged.
Action Not Matched - Only packets that do not match the rule parameters will be
logged.
Both – All packets will be logged.
Action Matched Press [SPACE BAR] and then [ENTER] to select the action for a matching packet.
Options are Check Next Rule, Forward and Drop.
Action Not
Matched
Press [SPACE BAR] and then [ENTER] to select the action for a packet not
matching the rule.
Options are Check Next Rule, Forward and Drop.
When you have Menu 21.1.1.1 - TCP/IP Filter Rule configured, press [ENTER] at the message “Press
ENTER to Confirm” to save your configuration, or press [ESC] to cancel. This data will now be
displayed on Menu 21.1.1 - Filter Rules Summary.