ZyXEL Communications ZyWALL 2 Plus - Manual (Page 503)

Chapter 32 DMZ Setup
ZyWALL 2 Plus User’s Guide
503
"
DMZ, WLAN and LAN IP addresses must be on separate subnets. You must
also configure NAT for the DMZ port (see
Chapter 36 on page 521 ) in menus
15.1 and 15.2.
32.3.2 IP Alias Setup
Use menu 5.2 to configure the first network. Move the cursor to the Edit IP Alias field, press
[SPACE BAR] to choose Yes and press [ENTER] to open Menu 5.2.1 - IP Alias Setup, as
shown next. Use this menu to configure the second and third networks.
Figure 327 Menu 5.2.1: IP Alias Setup
Refer to Table 186 on page 495 for instructions on configuring IP alias parameters.
Menu 5.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL: