ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 92)

P-793H User’s Guide
92 Chapter 5 WAN Setup
Figure 32 WAN > WAN Backup Setup > Advanced Setup > Edit
The following table describes the labels in this screen.
Table 22 WAN > WAN Backup Setup > Advanced Setup > Edit
LABEL DESCRIPTION
AT Command
Strings
Dial Enter the AT Command string to make a call.
Drop Enter the AT Command string to drop a call. “~” represents a one second wait, e.g.,
“~~~+++~~ath” can be used if your modem has a slow response time.
Answer Enter the AT Command string to answer a call.
Drop DTR When
Hang Up
Select this if you want the DTR (Data Terminal Ready) signal to be dropped after
the Drop string is sent out.
AT Response
Strings
CLID Enter the keyword that precedes the CLID (Calling Line Identification) in the AT
response string. This lets the ZyXEL Device capture the CLID in the AT response
string that comes from the WAN device. CLID is required for CLID authentication.
Called ID Enter the keyword preceding the dialed number.
Speed Enter the keyword preceding the connection speed.
Call Control
Dial Timeout Enter a number of seconds for the ZyXEL Device to keep trying to set up an
outgoing call before timing out (stopping). The ZyXEL Device times out and stops if
it cannot set up an outgoing call within the timeout value.
Retry Count Enter a number of times for the ZyXEL Device to retry a busy or no-answer phone
number before blacklisting the number.
Retry Interval Enter a number of seconds for the ZyXEL Device to wait before trying another call
after a call has failed. This applies before a phone number is blacklisted.
Drop Timeout Enter a number of seconds for the ZyXEL Device to wait before dropping the DTR
signal if it does not receive a positive disconnect confirmation.