ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 273)

P-793H User’s Guide
Chapter 26 Remote Node Setup 273
26.4 Remote Node Network Layer Options
Move the cursor to the Edit IP/Bridge field in menu 11.1, then press [SPACE BAR] to select
Yes. Press [ENTER]
to open Menu 11.3 - Remote Node Network Layer Options.
Figure 151 Menu 11.3: Remote Node Network Layer Options
Telco Option This section is only enabled for PPPoA or PPPoE connections.
Allocated Budget(min) Enter the maximum amount of time (in minutes) each call can last. Enter 0 if
there is no limit. With Period, you can set a limit on the total outgoing call time
of the ZyXEL Device within a certain period of time. When the total outgoing
call time exceeds the limit, the current call will be dropped and any future
outgoing calls will be blocked.
Period(hr) Enter how often (in hours) the Allocated Budget is reset. For example, if you
can call for thirty minutes every hour, set the Allocated Budget to 30, and set
this field to 1.
Schedule Sets Enter the schedule sets that apply to this connection.
Nailed-Up Connection Select this if you want the ZyXEL Device to automatically connect to your ISP
when it is turned on and to remain connected all the time. This is not
recommended if you pay for your Internet connected based on the amount of
time you are connected.
Session Options
Edit Filter Sets If you want to specify input and output filter sets for the WAN port, press
[SPACE BAR] to select Yes and press [ENTER]. Menu 11.1.4 appears.
Idle Timeout(sec) Enter the number of seconds the ZyXEL Device should wait while there is no
Internet traffic before it automatically disconnects from the ISP. Enter a time
interval between 10 and 9999 seconds.
Table 101 Menu 11.1: Remote Node Profile (node 8) (continued)
FIELD DESCRIPTION
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment = Static Ethernet Addr Timeout(min)= N/A
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= None
IP Policies=