ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 319)

P-793H User’s Guide
Chapter 33 System Information & Diagnosis 319
33.3 System Information and Console Port Speed
This section describes your system and allows you to choose different console port speeds. To
get to the System Information and Console Port Speed:
1 Enter 24 to go to Menu 24 - System Maintenance.
2 Enter 2 to open Menu 24.2 - System Information and Console Port Speed.
3 From this menu you have two choices as shown in the next figure:
Figure 199 Menu 24.2: System Information and Console Port Speed
33.3.1 System Information
System Information gives you information about your system as shown below. More
specifically, it gives you information on your routing protocol, Ethernet address, IP address,
etc.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
WAN This section displays information about the WAN port.
Line Status This field displays the port speed and duplex setting if you’re using Ethernet
encapsulation and Down (line is down or not connected), Idle (line (ppp) idle),
Dial (starting to trigger a call) or Drop (dropping a call) if you’re using PPPoE
encapsulation.
Transfer Rate This field shows the transmission speed in kilobits per second on this port.
CPU Load This field displays the percentage of CPU utilization.
You may enter 1 to reset the counters or [ESC] to return to menu 24.
Table 118 Menu 24.1: System Maintenance - Status (continued)
FIELD DESCRIPTION
Menu 24.2 - System Information and Console Port Speed
1. System Information
2. Console Port Speed