ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 204)

P-793H User’s Guide
204 Chapter 15 Remote Management Configuration
• The IP address in the Secured Client IP field does not match the client IP address. If it
does not match, the ZyXEL Device will disconnect the session immediately.
• There is already another remote management session with an equal or higher priority
running. You may only have one remote management session running at one time.
• There is a firewall rule that blocks it.
15.1.2 Remote Management and NAT
When NAT is enabled:
• Use the ZyXEL Device’s WAN IP address when configuring from the WAN.
• Use the ZyXEL Device’s LAN IP address when configuring from the LAN.
15.1.3 System Timeout
There is a system management idle timeout. The ZyXEL Device automatically logs you out if
the management session remains idle for longer than this timeout period. The management
session does not time out when a statistics screen is polling. The default value is five minutes,
and you can change or disable this in
Section 17.1.2 on page 227 .
15.2 WWW
Use this screen to change your ZyXEL Device’s World Wide Web settings. Click Advanced
> Remote MGMT to display the WWW screen.
Figure 95 Remote MGMT > WWW
The following table describes the labels in this screen.
Table 70 Remote MGMT > WWW
LABEL DESCRIPTION
Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the ZyXEL Device
using this service.