ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 82)

P-793H User’s Guide
82 Chapter 5 WAN Setup
Figure 26 WAN > More Connections > Edit
The following table describes the labels in this screen.
Table 18 WAN > More Connections > Edit
LABEL DESCRIPTION
General
Active Select the check box to activate or clear the check box to deactivate this
connection.
Name Enter a unique, descriptive name of up to 13 ASCII characters for this
connection.
Mode Select Routing from the drop-down list box if your ISP allows multiple computers
to share an Internet account.
If you select Bridge, the ZyXEL Device will forward any packet that it does not
route to this remote node; otherwise, the packets are discarded.
Encapsulation Select the method of encapsulation used by your ISP from the drop-down list
box. Choices are PPPoA, RFC 1483, ENET ENCAP or PPPoE.
If you set up a point-to-point connection, select either ENET ENCAP or RFC
1483.
User Name (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your
ISP assigned. If assigned a name in the form user@domain where domain
identifies a service name, then enter both components exactly as given.