ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 209)

P-793H User’s Guide
Chapter 15 Remote Management Configuration 209
15.6.3 Configuring SNMP
See Section 15.1 on page 203 for background information. Use this screen to change your
ZyXEL Device’s SNMP settings. Click Advanced > Remote MGMT > SNMP. The screen
appears as shown.
Figure 100 Remote MGMT > SNMP
The following table describes the labels in this screen.
Table 74 SNMPv2 Traps
OBJECT LABEL OBJECT ID DESCRIPTION
SNMPv2 Traps
Cold Start 1.3.6.1.6.3.1.1.5.1 This trap is sent when the switch is turned on.
WarmStart 1.3.6.1.6.3.1.1.5.2 This trap is sent when the switch restarts.
linkDown 1.3.6.1.6.3.1.1.5.3 This trap is sent when the Ethernet link is down.
linkUp 1.3.6.1.6.3.1.1.5.4 This trap is sent when the Ethernet link is up.
RFC 1493 Traps
newRoot 1.3.6.1.2.1.17.0.1 This trap is sent when the STP topology changes.
topology change 1.3.6.1.2.1.17.0.2 This trap is sent when the STP root switch changes.
Table 75 Remote MGMT > SNMP
LABEL DESCRIPTION
SNMP
Port You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Access Status Select the interface(s) through which a computer may access the ZyXEL Device
using this service.