ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 290)

P-793H User’s Guide
290 Chapter 28 NAT Setup
The first entry is for the Default Server. The following table describes the labels in this
menu.
28.4 General NAT Examples
The following are some examples of NAT configuration.
28.4.1 Internet Access Only
In the following Internet access example, you only need one rule where all your ILAs (Inside
Local addresses) map to one dynamic IGA (Inside Global Address) assigned by your ISP.
Figure 167 NAT Example 1
Table 111 Menu 15.2: NAT Server Setup
FIELD DESCRIPTION
Rule This field is a sequential value, and it is not associated with a specific rule. The
sequence is important, however. The ZyXEL Device checks each active rule in
order, and it only follows the first one that applies.
Start Port This field displays the beginning of the range of port numbers forwarded by this
rule.
End Port This field displays the end of the range of port numbers forwarded by this rule.
If it is the same as the Start Port, only one port number is forwarded.
IP Address This field displays the IP address of the server to which packet for the selected
port(s) are forwarded.