ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 278)

P-793H User’s Guide
278 Chapter 26 Remote Node Setup
26.7 Advance Setup Options
Move the cursor to the Edit Advance Options field in menu 11.1 (only for remote node 1),
then press [SPACE BAR] to select Yes. Press [ENTER]
to open Menu 11.8 - Advanced
Setup Options.
Figure 154 Menu 11.8: Advance Setup Options
The following table describes the fields in this menu.
Menu 11.8 - Advance Setup Options
PPPoE pass-through= No
Table 105 Menu 11.8: Advance Setup Options
FIELD DESCRIPTION
PPPoE pass-through In addition to the ZyXEL Device's built-in PPPoE client, you can enable PPPoE
Passthrough to allow up to ten hosts on the LAN to use PPPoE client software
on their computers to connect to the ISP via the ZyXEL Device. Each host can
have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for applications where NAT is not
appropriate.
Disable PPPoE passthrough if you do not need to allow hosts on the LAN to
use PPPoE client software on their computers to connect to the ISP.
Once you have completed filling in this menu, press [ENTER] at the message “Press ENTER to
Confirm...” to save your configuration and return to menu 11.1, or press [ESC] at any time to cancel.