ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H - Manual (Page 425)

P-793H User’s Guide
Appendix J Log Descriptions 425
Log Commands
This section provides some general examples of how to use the log commands. The items that
display with your device may vary but the basic function should be the same.
Go to the command interpreter interface. Appendix G on page 401 explains how to access and
use the commands.
Configuring What You Want the ZyXEL Device to Log
1 Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the ZyXEL Device is to record.
2 Use sys logs category to view a list of the log categories.
Figure 270 Displaying Log Categories Example
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
Figure 271 Displaying Log Parameters Example
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Use 0 to not record logs for that category, 1 to record only logs for that
category, 2 to record only alerts for that category, and 3 to record both
logs and alerts for that category. Not every parameter is available with
every category.
5 Step 5.Use the sys logs save command to store the settings in the ZyXEL Device (you
must do this in order to record logs).
Displaying Logs
• Use the sys logs display command to show all of the logs in the ZyXEL Device’s log.
ras>?
Valid commands are:
sys exit ether aux
ip ipsec bridge bm
certificates cnm 8021x radius
ras>
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both]