Toshiba Tohsiba Electromagnetic Flowmeter Converter L5232 - Manual (Page 34)

6F8A0917
- 33 -
• Wirering
・ Hole position of cable connection mouth of LF232* F is the same as LF502 (type FS2).
・ Because specifications of cable connection mouth are different in the following points,
Please be careful.
Table 5.4 Cable connection mouth specification comparison list
(Partially filled pipes type)
Model LF502 LF502 (type FS2) LF232*F
Joint of case side (Please use only an
attached cable ground)
M27 slim screw
Depth 0.433 inch (11mm)
G1/2
Depth 0.433 inch (11mm)
Materials Stainless steel Stainless steel Nylon resin
Grade of waterproofing
IP67 IP67
IP67
Diameter of conformity
cable
Excitation, optional
cable
φ0.433～0.512 inch
(φ11～13mm)
Others
φ0.394～0.472 inch
(φ10～12mm)
Excitation, DI/DO
cable
φ0.433～0.512 inch
(φ11～13mm)
Others
φ0.394～0.472 inch
(φ10～12mm)
φ0.433～0.512 inch
(φ11～13mm)
Joint of conduit Rc（PT）3/4 male screw R(PT)1/2 male screw None
specifications of
attached cable
ground
Blind Attached waterproofing
blind
Attached waterproofing
blind
Attached protection
against dust blind
(Note)
(Note) There is not waterproofing of a blind. When converter needs waterproofing, please set
waterproof the cable connection mouth.
Terminal block specifications of LF232 are M4 screw terminals same as LF502.
Change of terminal processing of cable is unnecessary.