Siemens Simatic S7-400 - Manual (Page 257)

Analog Modules
5-41
S7-400, M7-400 Programmable Controllers Module Specifications
A5E00069467-07
Table 5-42 Parameters of the Analog Input Modules, continued
Parameter Scope Parameter
Type
Default 2) Value Range
Measurement
•
Measuring type Disabled
U
Voltage
4DMU Current
(four-wire transmitter)
2DMU Current
(two-wire transmitter)
R-4L Resistance
(four-conductor connection)
R-3L Resistance
three-conductor connection
RTD-4L Thermal resistor
(linear, four-conductor
connection)
RTD-3L Thermal resistor
(linear, three-conductor
connection)
TC-L Thermocouple (linear)
U
Static Channel
•
Measuring range For the settable measuring ranges of
the input channels, please refer to the
individual module description. " 10 V
•
Reference
temperature – 273.15 to 327.67 o C 0 o C
Dynamic Module
•
Temperature unit Degrees Celsius; degrees Fahrenheit;
Kelvins Degrees
Celsius
Static Module
•
Temperature
coefficient for
temperature
measurement with
thermal resistor
(RTD) Platinum (Pt)
0.00385
W/W
/ ° C
0.003916 W/W / ° C
0.003902 W/W / ° C
0.003920 W/W / ° C
Nickel (Ni)
0.00618
W/W / ° C
0.00672 W/W / ° C
0.00385
Static Channel
•
Interference
frequency
suppression 400 Hz; 60 Hz; 50 Hz; 10 Hz; none 50 or 60
Hz
•
Smoothing None
Low
Average
High None
•
Reference junction None
Internal
RTD on channel 0
Reference temperature value dynamic None
1) If you use the module in ER-1/ER-2, you must set this parameter to “No” because the interrupt lines are
not available in ER-1/ER-2.
2) Only in the CC (central controller) is it possible to start up the analog modules with the default settings.