KORG PA4X 76 - Manual (Page 836)

832| Audio In/Out and the Voice Processor
Programming the EQ
▪ Look at the results of any edit in the diagram . The diagram shows the EQ
curve. Its shape changes depending on the various parameter values.
▪ Use the Gain parameter to change the emphasis or attenuation of the cor-
responding band. Use it to make the frequencies stronger or weaker.
▪ Use the Freq parameter to change the center frequency of the correspond-
ing band. Center it on the problematic frequency, or the harmonics you want
to emphasize or attenuate.
▪ Use the Q parameter to adjust the ‘quality’ of the EQ filter; higher values
correspond to narrower, more accurate filters. Use higher values for near-
surgical correction on isolated frequencies, lower values for more musical,
softer equalization.
▪ Use the On/Off buttons under each band to turn the corresponding bands
on or off.
Editing the MaxxAUDIO Master
The MaxxAUDIO Master controls the MaxxBass, MaxxTreble, MaxxStereo and
MaxxVolume effects. It is positioned at the end of the signal chain, just be-
fore the audio outputs, adds to the sound deeper, richer bass, and cleaner,
warmer, more articulate treble with no loss of RMS (that is, average per-
ceived volume). Processing also results in a stereo image that’s wider and
more accurate.
Please keep in mind that summing-up all levels could cause distortion in the
PaAS Amplification System or in external amplification systems. Be careful
not to max-out all sliders.
Accessing the MaxxAUDIO Master
▪ Go to the Global > MAXX Master EQ > Master page.