KORG PA4X 76 - Manual (Page 522)

518| Effects for the Sounds
e Tap2 Level 0…100 Sets the Tap2 output level
Pan L, 1…99, R Sets the stereo image of tap2
FB Amt –100…+100 Sets the Tap2 feedback amount
f Tap3 Level 0…100 Sets the Tap3 output level
Pan L, 1…99, R Sets the stereo image of tap3
FB Amt –100…+100 Sets the Tap3 feedback amount
g Feedback 0…100 Sets the amount of feedback for Taps 1, 2,
and 3
Src Off…Tempo Selects the modulation source of feedback
amount
Amt –100…+100 Sets the feedback amount
h High Damp [%] 0…100 Sets the damping amount in the high range
Low Damp [%] 0…100 Sets the damping amount in the low range
i Saturation 0…100 Sets the distortion amount
j Input Trim 0…100 Sets the input gain
Pre Tone 0…100 Sets the tone of the input
k Wow Flutter [Hz] 0.02…1.00 Sets the frequency at which pitch variation
will occur
Wow Flutter depth 0…100 Sets the depth of pitch variation
l Wet/Dry Dry, 1:99…99:1,
Wet Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Delay (Tap1) [msec]
a: Src
a: Amt
b: Tap2 Position [%]
b: Tap3 Position [%]
The delay time for Tap 2 and 3 is specified as a proportion (%) relative to
“Delay (Tap1).” Even if you use dynamic modulation to control “Delay (Tap1),”
Tap 2 and 3 will change at the same proportion.